Microcement KC Poolciment is a type of Microcement especially developed to coat pools e surfaces in permanent contact with water. This allows a continuous coating without joints, thus improves airtightness, which does not happen with other types of coatings. With a high level of customisation, this ideal coating for swimming pools, lets you choose from a wide choice of colours available and also allows the application of mosaics and emblems.

This coating keeps on of the mainly advantages of Microcement, you could apply it to almost all surfaces, which doesn’t cause noise or debris.

See KC Poolciment Applications.

Microcement Features for Pools – KC Poolciment

The formula used in this type of Microcement Kcberry is based on the latest technologies used in skyscrapers, whose structures are based on high-strength materials, with a durability three times higher than traditional concrete.

Microcement Poolciment is a compact e waterproof coating with a reduced capillary network which, in contact with water increases its efficiency, thus doesn’t need any sealer to ensure their water resistance. Even so, instead of the Sealer we applied Poolsealer. The Sealer that provide watertightness tend to be insensitive to negative pressure, thus, over time, stains and blisters may appear which eventually leave and allow the water to attack the coating. Our lining for swimming pools – Poolciment – is impermeable to water but permeable to water vapor ensures a wide lifetime of this Microcement Kcberry.

Microcement Application for Pools 

This application is different of the other types of Microcement Kcberry, since this isn’t used Fiberglass mesh and has different sealing process.

This Pool coating has two granulometries:

Poolciment XL Application

Used either as support, as a basis of the coating, which can later give the finish desired, a rough texture or anti-slip.

MIX AND INCOME

• 10 Kg – 2,50 L Royal Resin
• 2 Coats – 3,00 Kg/m²

APPLICATION

– Microcement Poolciment should be applied to shotcrete. The surface must be clean, consolidated and in good condition of planimetry,

– Apply a primary coat of Royal Resin with roll on the surface. It is not necessary leave to dry,

– Apply the first coat of Poolciment (no pigment) e allow to dry 24h. Drying time depends on Weather conditions,

– Apply the second coat of Poolciment (no Pigment) e allow to dry 24h,

– Sand each applied coat,

– We must always respect the proportions recommended mixture.

Poolciment M Application

We recommend that use this kind of Poolciment only as finish once it offers a slightly textured finish therefore can’t be used as base coat.

MIX AND INCOME

• 10 Kg – 3,00 L Royal Resin
• 2 Coats – 1,80 Kg/m²

APPLICATION

– Apply two pigmented coats of Poolciment M on Poolciment XL

– Sand each applied coat,

– Wash thoroughly and without exerting any pressure surface with water, avoiding the accumulation of water. Let dry for 24 hours.

– Apply 2 coats of Poolciment to roll, fully covering the entire surface in each hand with an interval of 24 hours and allow to dry for 5 days.

Cleaning and Maintenance – KC Poolciment

In order to facilitate cleaning and maintenance that has achieved unparalleled quality, this coating for swimming pools apply a final coat Poolsealer that penetrates deeply into the capillary Microcement Kcberry network in order to form crystals and preventing the penetration of water, acids and salts. In other hand other coverings where use protectors that create a surface film whose outcome immersion is unreliable.